12V to 30V/32V Converter

DIY DC DC Step-up Boost

Model Number: HY-SB1635
Input Voltage: 10-32V
Output Voltage: 12-35V Adjustable
Output Current: 10A MAX
Product description: DIY DC DC Step-up Boost
INQUIRY

DC DC Step-up Boost 10-32V to 12V-35V Adjustable Converter Module DIY 150W

Model	HY-SB1635
Module Properties	non-isolated step-up module (BOOST)
Input rated voltage	DC 12V
Input voltage range	DC 10-32V
Input Current	16A MAX (Please enhance heat dissipation if more than 10A)
Conversion efficiency	94% (measured at Input 16V, output 19V 2.5A)
Output voltage	DC 12-35V Adjustable
Output current	10A MAX
Output rated power	100W MAX natural cooling Easy to drive 65W 90W dual-core notebook. Use a 12V battery drive 19V 3.42A notebook, the module temperature about 45°c
Output peak power	150W MAX enhance heat dissipation
Voltage regulation	± 0.5%
Load regulation	< 2%
Working temperature	-40°c ~+85°c( If ambient temperature exceeds 40°c, lower power use, or to enhance heat dissipation)
Output Ripple	2% (MAX) 20M-bandwidth
Rectification	synchronous rectification
Full load temperature rise:	45°c
No-load current	25mA typical
Dynamic response speed	5% 200uS
Protection	Over-current, Over-temperature
Short-circuit protection	NO, if need pls add fuse on the positive pole on input
Input Reverse Polarity Protection	None (Please Series diode at the input port.)
Connection	solderless terminal
Wiring	the above chart, .IN + input positive, IN- input negative, OUT + Output +, OUT- output negative.
Product Weight	70G
Product size	653723.5mm
Applications:	1. DIY output adjustable car power supply, connect 12V battery and output could be 14-35V(adjustable freely).Please make sure that the output voltage is higher than the input voltage. 2. Car laptop power supply: connected to 12V power supply, output voltage regulation as your notebook need. 3. Boost charger, you can use the 12V power supply is higher than 12V battery charging, such as 24V battery. 4. The power supply for your electronic device, as long as the voltage is adjusted to the voltage you need and the current does not exceed the rated current is able to work properly. 5. Pre-supply system, when you do a project when the time 10-18V input, and your system board 24V power they need about its great power, with ordinary DC-DC power module too small, then you choose this module we will be your best choice, no debugging directly on the machine can work easily achieve efficient high-power boost
Attention	1. Within one meter lead wire length not less than 1.5 square feet, if greater than 1 m length wire, bold, recommended 2.5 to 4 square feet of line is better 2. The module operates at high power, high temperature, plus time to install the fan housing, low power without adding a fan, be sure the module heat sink temperature should not exceed 80 degrees. 3. Using the input can not be reversed output can not be shorted. 4.12V battery discharge voltage can not be lower than 10.5V, Li-ion battery used in tandem (single 3.7V) discharge voltage can not be lower than 2.7V.
Other output current option for 12V to 24V	1A, 2A, 3A, 5A, 8A ,10A, 12A, 15A(pls contact with our sales manager if need)
Attention: >Pls install according to the the label strictly,positive pole and nagative pole can’t be reversed, or the module and device might be damaged >To assure this converter has the sufficient voltage and power pls make sure the voltage and power input is enough.